WRITING A ROUTINE IN A TOOLBAR

Moderator: Carlson Support

WRITING A ROUTINE IN A TOOLBAR

Postby jbaldeo » Thu Nov 15, 2012 1:52 pm

Could anyone explain how I can write a routine in a toolbar to draw a leader with a curve using just 3 picks ? Presently I would have to select Dimleader, pick the first and second point, then select F (Format), then enter, then select SP (Spline), then enter, then pick the third point, then enter and enter again and then select N (None) and then enter to complete.
JB1
jbaldeo
 
Posts: 51
Joined: Wed Jul 25, 2012 1:45 pm

Re: WRITING A ROUTINE IN A TOOLBAR

Postby Nava Ran » Fri Nov 16, 2012 2:34 pm

Try:
Draw>Leader>Curve Arrow
or
Draw>Leader>Bold Curve Leader
Nava Ran
 
Posts: 155
Joined: Tue Dec 18, 2007 3:12 pm
Location: Israel

Re: WRITING A ROUTINE IN A TOOLBAR

Postby jbaldeo » Fri Nov 16, 2012 2:57 pm

thanks, but i need to use that dimleader and write a routine to bypass the un-neccessary steps
JB1
jbaldeo
 
Posts: 51
Joined: Wed Jul 25, 2012 1:45 pm


Return to Civil

Who is online

Users browsing this forum: No registered users