Page 1 of 1

Profile Inverts

PostPosted: Thu Jan 20, 2022 2:48 pm
by dressler
I am drawing sewer profiles from the network, and the pipe crossing labels are adding the pipe thickness to invert elevation. Is there a way to stop this from happening, and just show the invert that is shown in the actual network file?

Example: Have a pipe coming into a manhole at 5.98, but the pipe crossing label is showing 5.93 due to the 0.05 pipe thickness.

The pipe crossing label should be ready 5.98 like the network is showing.

Thanks,

Dustin