Custom linetype

Custom linetype

Postby sjscoach » Tue May 02, 2023 12:43 pm

So trying to make a buffer zone linetype. All I was a "B" in the line and can't get it to work.

I tried using the Polyline to special line command but the B's come in too small and I can't figure how to make them bigger.

If you have any thoughts you could share it would be appreciated.
sjscoach
 
Posts: 11
Joined: Fri Oct 08, 2021 4:58 pm
Location: Hopedale, MA

Return to IntelliCAD General

Who is online

Users browsing this forum: No registered users

cron