Carlson Software Forum

When using field to finish, I use the option to draw linework on 3d axis. This works great on lines, but it breaks my arcs into segmented facets or chords, and I understand why.
What controls the number of facets or chords? I would like to reduce that number.
Thanks.

I will answer my own question in case anyone has the same.
I just called Carlson support and talked to a friendly and super helpful support tech, Greg. (Thanks Greg, did not get your last name.)

Its under Settings, Carlson Configure, General Settings, Remove Arcs.
You can do max offset or chord length.

Thanks again, Greg at Carlson support.

Chris.