Point Compare

Moderator: Carlson Support

Point Compare

Postby cbnelson » Thu Jun 17, 2021 11:09 am

I get a fair number of messages that drawing points and crd points don't match. When I review the points the crd file reports negatives of the coordinate values in the drawing.

DWG Point# DWG Northing DWG Easting DWG Elevation Delta North Delta East Delta Elevation

107 5101.44 5159.92 7.37 -5101.4400 -5159.9200


It seems cosmetic because when I export the points there are no negative numbers.
It is a little worrisome thinking I may give a crew bad coordinates when I am rushed.
Any one else have this happen?
Never under estimate an old man who is a Surveyor!
cbnelson
 
Posts: 11
Joined: Wed Aug 24, 2016 1:11 pm
Location: South Carolina

Re: Point Compare

Postby gskelhorn » Fri Jun 18, 2021 9:12 pm

cbnelson wrote:I get a fair number of messages that drawing points and crd points don't match...

DWG Point# DWG Northing DWG Easting DWG Elevation Delta North Delta East Delta Elevation

107 5101.44 5159.92 7.37 -5101.4400 -5159.9200



My interpretation of this is you are comparing points that have values with ones that have coordinate values of 0.000 0.000
Since the comparison is using a DWG then check if there are points drawn at (0.000,0.000), possibly on a layer that is turned off or frozen?
gskelhorn
 
Posts: 158
Joined: Tue Nov 03, 2009 12:56 am


Return to Survey

Who is online

Users browsing this forum: No registered users