Page 1 of 1

Point Compare

PostPosted: Thu Jun 17, 2021 11:09 am
by cbnelson
I get a fair number of messages that drawing points and crd points don't match. When I review the points the crd file reports negatives of the coordinate values in the drawing.

DWG Point# DWG Northing DWG Easting DWG Elevation Delta North Delta East Delta Elevation

107 5101.44 5159.92 7.37 -5101.4400 -5159.9200


It seems cosmetic because when I export the points there are no negative numbers.
It is a little worrisome thinking I may give a crew bad coordinates when I am rushed.
Any one else have this happen?

Re: Point Compare

PostPosted: Fri Jun 18, 2021 9:12 pm
by gskelhorn
cbnelson wrote:I get a fair number of messages that drawing points and crd points don't match...

DWG Point# DWG Northing DWG Easting DWG Elevation Delta North Delta East Delta Elevation

107 5101.44 5159.92 7.37 -5101.4400 -5159.9200



My interpretation of this is you are comparing points that have values with ones that have coordinate values of 0.000 0.000
Since the comparison is using a DWG then check if there are points drawn at (0.000,0.000), possibly on a layer that is turned off or frozen?